部分相干电磁光束在湍流介质中传输的偏振变化

 从推广的惠更斯-菲涅尔原理出发，推导出了部分相干电磁光束的偏振态在湍流介质中传输的表达式。并以电磁高斯-谢尔模型(EGSM)光束为例，研究了湍流对电磁高斯-谢尔模型光束偏振态的影响。研究结果表明，对于轴上点，湍流介质的折射率结构常数越大，偏振度趋于最大值的速度越快，达到的最大值越小；光斑越大，偏振度达到最大值的位置离光源越远，在光斑增大的过程中，偏振度所达到的极大值会先增大后减小，最后保持与光源相同的偏振度不变。对于轴外点，一个固定的z，光的偏振度随着离轴距离的增大而逐渐下降，并最终等于零。折射率结构常数越大，偏振度随离轴距离的增大而下降得越缓慢；光斑越大，偏振度随离轴距离的增大下降得越快。     

工作气压对电子束沉积ZrO2薄膜折射率和聚集密度的影响

采用电子束蒸发的方法，用石英晶体振荡法监控薄膜的蒸发速率，在不同工作气压下制备了ZrO2薄膜样品.在相调制型椭圆偏振光谱仪和分光光度计上对样品的光谱特性进行了测试.根据波长漂移的理论，计算出薄膜的聚集密度.结果表明，随着工作气压的降低，薄膜的聚集密度和折射率都随之增大.     

相变光盘介电薄膜ZnS-SiO2 的微结构和光学特性

采用射频磁控溅射法制备了ZnS-SiO₂ 介电薄膜,利用透射电镜和椭偏仪研究了溅射条件对ZnS-SiO₂薄膜微结构和折射率n的影响.研究表明,ZnS-SiO₂薄膜中存在微小晶粒,大小为2～10 nm的ZnS颗粒分布在SiO₂基体中,当溅射功率和溅射气压变化时,ZnS-SiO₂薄膜的微结构和折射率n发生显著变化,微结构的变化是导致折射率n变化的主要原因,通过优化溅射条件可以制备适用于相变光盘的高质量ZnS-SiO₂介电薄膜.     

Refractive index of standard oils as a function of wavelength and temperature

The refractive indices (n) of eight standard oils from Physikalisch Technische Bundesanstalt, Germany were determined with an accuracy of ±1×10⁻⁴ by using Abbe Refractometer. The measurements were performed at temperature 20°C in the spectral range 0.4–0.7 μm. The experimental data were fitted to the simple Cauchy dispersion formula and the results were found to be consistent within the limits of experimental error. In all cases, the refractive index decreased monotonically with increasing wavelength. The refractive indices (n) of these oils have been measured as a function of the temperature t (20°C up to 50°C) at λ=0.589 μm and were found to have linear temperature dependencies. The refractive indices of the studied oils and the uncertainty in their values are calculated at λ=0.589. The Lorentz–Lorenz (L–L) formula has been tested and it was found to be valid with a maximum deviation of 0.4% and was used to calculate the molecular polarizability θ.     

用反射法自动测量大尺寸样品的折射率分布

针对大尺寸样品的折射率分布测量,引入自动扫描装置和适时数据处理系统,研究出一种高灵敏度的智能化反射法折射率分布测量仪,可进行快速、自动、准确的折射率分布测量.经理论分析和实验研究提出了一套合理的实验数据处理方法.并具体介绍和详尽分析了实验装置,讨论了有关理论和实验误差,给出了消除各种误差的有效方法,最终得出较为理想的实验结果.     

Technique for Monolithic Fabrication of Microlens Arrays Integrated with Infrared CCD

Based on scalar diffraction theory, 8-phase-level 256×256 elements diffractive microlens array with element dimension of 50×33 μm2 have been fabricated on the back-side of PtSi(3～5 μm) infrared CCD. The measurement results indicated that the ratio of the signal-to-noise of the infrared CCD with microlens was increased by a factor of 2.8.     

Widely tunable long-period fiber grating with nm-thick higher refractive index film overlay

By introducing a four-layer step-index waveguide modeling, the characteristics of long-period fiber grating (LPFG) with an nm-thick film overlay, which has higher refractive index than that of fiber cladding are investigated in detail. The influence of both the overlay thickness and refractive index on the tuning ability of LPFG is analyzed. The numerical results demonstrate that spectral response of LPFG is divided into three distinct regions as the overlay deposition increases and the shift of resonant wavelength is drastic in some special thickness range. In conjunction with higher-order cladding mode coupling and fiber cladding etching, the sensitivity of LPFG to the overlay refractive index is enhanced significantly and over 120 nm resonant wavelength tunable range is achieved.     

用于近场集成光学头微透镜器件的灰度掩模技术

讨论了制作适用于近场集成光学头中的凸形、凹形微透镜和折衍射复合微透镜的灰度掩模技术。定性地给出了与几种典型的凸形、凹形微透镜和折衍射复合微透镜对应的灰度掩模版的设计实例 ,以及将它应用于光刻操作的情况 ,为采用灰度掩模技术制作适用于近场集成光学头中的微透镜器件奠定了基础。灰度掩模技术在微透镜器件的制作方面具有重要的应用前景 ,有助于简化制备工艺 ,降低制作成本 ,优化微透镜阵列的结构参数。     

Optical and conductive properties of AlSi-alloy/SiCp composites: application in modelling CO2 laser processing of composites

The optical properties—reflectivity, real part of the refractive index, absorption coefficient as well as the thermal and electrical conductivity of AlSi-alloy/SiC_p composite were measured. The optical parameters and both conductivities decreased with the increase of SiC_p particles volume in AlSi-alloy matrix. This decrease was almost linear for the volume fraction of SiC_p particle up to 10 vol% of the total mass of the composite. For the 15 vol% of SiC_p particles, the departure from linearity is connected with the presence of additional phases in AlSi-alloy/SiC_p composite materials. The measured temperature dependencies of optical reflectivity and electrical conductivity for AlSi-alloy/SiC_p 15 vol% are of metallic character. Modelling of the interaction of the CO₂ laser radiation with AlSi-alloy/SiC_p 15 vol% composite should allow to estimate the initiation time at which the surface composite reaches melting temperature.     

红外折/衍混合离轴望远系统设计

本文针对空间光学系统轻型特点,设计了一个二元光学折/衍混合红外反射式望远系统。采用了离轴式格里高利(Gregorian)结构形式,消除了望远系统中的中心遮拦问题。用衍射光学元件校正系统象差,使反射面为球面,二元光学表面尺寸比施密特(Schmidt)校正板(位于入瞳处)缩小于3～4倍,光学设计运用OSLO软件,光学系统的通光孔径φ=120mm,焦距f=-1000mm,波长λ=4.3μm,视场2ω=2°×6°(子午×弧矢),分辨率Res=0.05mm,MTF≥0.4(空间频率fre≤10cl/mm).